Fayat Dynapac F80W, Operating Manual

Page: 91 / 198

85 F80W
8
10
11
P
0
R
F 8
451072A
1
21
22
451076B
26
23
OPERATING MANUAL
2.5.11 Stopping the machine and engine
Stopping the machine:
• Stop and brake the machine by changing the travel control-
ler (8) to the neutral position (N). The parking brake indicator
lamp (23) lights up.
• Set the engine speed adjusting controller (10) to the idle
speed.
• Switch over the key in the ignition box (11) to the position
“0“.
• Remove the key from the ignition box (11) and disconnect
the battery disconnecter.
Machine emergency stop
Activation:
• Press the emergency brake button (1).
• The machine brakes, the engine stops, material distribution
on the conveyor stops, and vibration units and the screed
gas heating stops.
• The battery charging indicator lamp (21), engine lubrication
indicator lamp (22) and emergency brake indicator lamp
(26) will light up on the display.
Deactivation:
• Pull out the emergency brake button (1). Shift the travel
controller (8) to the neutral position (N); the machine can be
started again in this position.
Use only if a failure occurs when it is impossible to stop
the engine with the key in the ignition box or if serious
emergency occurs when it is impossible to stop the ma-
chine by moving the travel control (8) to the neutral po-
sition (N)!
Turn off the battery disconnecter when shutting down
the machine.
When the machine is put out of operation, protect the
dashboard and the engine compartment from unauthor-
ized access of others by locking the dashboard cover and
the engine bonnet.