Fayat Dynapac F80W, Operating Manual

Page: 61 / 198

55 F80W
OPERATING MANUAL
2.2.4 Removing chemical preservatives and
putting the machine into operation
Each of the machines, on which the preservative treatment was
carried out, must be provided with instructions for removing
the preservatives.
Instructions for removing the preservatives must specify proce-
dures to remove the preservatives and procedures to reinstall
the dismantled parts of the machine. Besides, a list of tools, in-
struments and devices must be specified, which are required for
performing the working procedures.
Always follow the working instructions for removing the
chemical preservatives and procedures for reinstalling
the dismantled machine parts. Observe safety precau-
tions stated in the instructions for removing the chem-
ical preservatives.
After the preservation and storage of the machine for more
than 2 months, carry out the following tasks:
• unlock the machine hopper,
• unlock the protective covers of the individual instruments
and covers of the machine,
• adjust the roof of the machine to the highest working po-
sition,
• if the machine is equipped with a gas bottle, mount the gas
bottle on the machine.
Then it is recommended to perform the following tasks:
• service lubrication points according to instructions stated in
the manual,
• check the tyres for pressure if the machine is equipped with
wheels,
• check that the coolant has the desired antifreeze properties,
• mount the batteries on the machine; recharge them accord-
ing to instructions of the manufacturer,
• clean the chromium-plated surface of piston rods from
chemical preservatives,
• remove protective components of the hole seals, through
which atmospheric precipitations can penetrate in internal
cavities of parts of the individual components of the ma-
chine,
• remove protective components from headlamps and exteri-
or mirrors of the machine,
• check parts of the electrical installation,
• remove chemical preservatives and protective elements of
the engine according to instructions of the manufacturer of
the engine.
• Remove all the chemical preservatives from the machine by
washing.
Wash the machine only in areas with intercepting traps
to intercept the contaminated water and detergents.
After the preservation and storage of the machine for
a time interval longer than 2 months, before the ma-
chine is put into operation, it is necessary to replace all
filter and air elements according to instructions stated in
this Operating Manual.