Fayat Dynapac F80W, Operating Manual

Page: 165 / 198

159 F80W
D451126C
1
MAINTENANCE MANUAL
Battery charging procedure:
• Open the left material hopper side cover (1).
• Clean the battery surface.
• Remove the battery from the machine.
• When disconnecting the battery, first disconnect the cable
of the (-) pole.
• Charge the battery.
• Mount the battery on the machine.
• Check the condition of the (+) pole, (-) pole and clamps.
• Clean the (+) pole, the (-) pole and the clamps.
• Apply a thin layer of grease on the clamps.
• When connecting the battery, first connect the (+) pole.
• Close the left material hopper side cover (1).
Note
Perform battery charging as needed according to instructions of
the battery manufacturer.
Perform battery check when the machine is parked on
a flat and solid surface with the engine and battery dis-
connecter off.
When checking the battery, use the prescribed protec-
tive equipment.
Perform battery charging as needed according to in-
structions of the battery manufacturer.
Do not eat, drink and smoke and do not use a naked
flame while working. Danger of fire!
Keep the battery dry and clean. Charge the battery if it
is low.
Perform battery charging outside the machine.
First disconnect the minus pole cable (-) when discon-
necting the battery. First connect the plus pole cable (+)
when connecting the battery.
Do not disconnect the battery when the engine is
running.
Disconnect the battery when repairing the machine
wiring.
Disconnect the battery when welding on the machine.
Caution! Never make direct conductive connection be-
tween both poles of the battery to avoid a short circuit
and a hazard of explosion of the battery.
Do not check live wires by touching the machine frame.
In case of electrolyte spillage, wash the affected area
with water and neutralize with lime.
Hand over the old inoperative battery for disposal ac-
cording to the national regulations.