Fayat Dynapac F80W, Operating Manual

Page: 151 / 198

145 F80W
1
1
451118
18
17
451082A
MAINTENANCE MANUAL
3.6.11 Auger cleaning
Before applying the anti-adherent solution remove gross dirt
from the augers.
Clean the driver’s stand always on the machine which is parked
on a flat and solid surface, with the machine engine and battery
disconnecter off.
Cleaning procedure:
• Make sure the screed heating system is turned off.
• Apply the anti-adherent solution on augers (1).
• Use a scraper to remove material residues from the augers
(1) on both sides of the machine.
• Start the engine.
• Activate the function of auger start by shifting the operating
mode switch (17) to the lower position and the switch (18)
on the main dashboard to remove the dirt from the augers.
• After removing dirt from the augers disable the switch (18)
and the operating mode switch (17) functions.
• Turn off the engine and disconnect the battery disconnect-
er.
• Apply the anti-adherent solution on augers (1).
Caution! There is a risk of injury during cleaning.
Caution! There is a risk of burns.
Remove dirt from the augers using a scraper only with
the engine and battery disconnecter off.
Use the prescribed protective equipment during
cleaning.
Use the prescribed anti-adherent solution according to
Chapter 3.2.4.
It is prohibited to use diesel oil instead of an anti-adher-
ent solution.