Fayat Dynapac F80W, Operating Manual

Page: 114 / 198

108 F80W
D451191
5 m
451102C
11
2.6 Operation of the screed
2.6.9 Loading material to the machine
Always load the material into the machine at the place of pav-
ing, just before performing paving.
The beacon of the machine must be activated when loading
a material to the machine.
Procedure for loading the machine
• Start the engine.
• Lower the screed to the ground.
• Make sure the warning beacon is connected.
• Turn off the engine.
• Turn the key in the ignition box (11) from position “0” to po-
sition “I”.
• The beacon is activated.
• Leave the driver’s stand.
• Open the hopper extension.
• Make sure there are no persons in the dangerous area of the
machine.
• Move away from the danger zone of the machine.
• Wait until the loader moves away from the danger zone of
the machine.
• Close the hopper extension.
• Get on the driver's stand.
• Switch over the key in the ignition box (11) from position “I”
to position “0“.
• The beacon is deactivated.
It is prohibited to load the material to the machine dur-
ing machine operation. The machine must be parked on
a flat and solid surface with the engine off and with the
activated beacon.
Risk of burns when loading the machine.
The material is hot. Its temperature ranges from approx.
120 to 180°C.
Leave the driver's stand and move to a safe distance,
before loading the machine with material. The safe dis-
tance is at least 5 metres.