Fayat Dynapac F80W, Operating Manual

Page: 147 / 198

141 F80W
451120
24
451064G
451802A
11
12
D
MIN
MA
X
1
2
3
4
D
451198
MAINTENANCE MANUAL
Gas flame position adjustment:
• Open the access to the burners.
• Insert the key into the ignition box (11) in the position “0”
and switch over to the position “I”.
• Set the key between position “I” and “II” and the engine
glowing indicator lamp (24) will light up.
• Do not perform engine glowing for more than 15 s.
• Use the alarm horn (12) to signal that the engine is starting.
• Turn the key to position “II” to start the engine.
• Secure the screed against free fall.
• Set the maximum paving width on both sides of the machine.
• Turn the key in the ignition box (11) from position “II” to po-
sition “I”. The engine switches off.
• Turn the key in the ignition box (11) from position “I” to posi-
tion “0” and disconnect the battery disconnecter.
Gas flame adjustment procedure:
• Have the correct position of the gas flame adjusted.
• Have the flame position adjustment performed by an au-
thorised service plant or qualified personnel according to
the procedure given below.
• Adjust the distance (D) between the gas burner (3) and the
spark plug (4).
• Adjust the distance (D) by loosening the gas burner set
screw (1) on the burner holder (2).
• The distance (D) can only be adjusted within the MIN and
MAX marks. The values of MIN and MAX are marked on the
burner holder (2) by marks.
• After adjusting the burner (3), tighten the burner set screw
(1) on the burner holder (2).
• Test the ignition of the burners. In case of incorrect adjust-
ment, repeat the gas flame adjustment procedure.
Perform gas flame adjustment when the machine is
parked on a flat and solid surface with the engine and
battery disconnecter off.
Have the gas flame adjustment performed by an author-
ised service plant or qualified personnel according to the
given procedure.
There is a risk of burns. Use protective equipment.
There is a risk of explosion.
Do not smoke during machine operation. There is a risk
of explosion or fire. Liquid gas can easily ignite.
The machine must be equipped with a fire extinguisher.
Have the fire extinguisher ready on the driver's stand at
a place intended for this purpose.
NO NO OK