Fayat Dynapac F80W, Operating Manual

Page: 87 / 198

81 F80W
12
1
451063A
13
11
8
10
23
21
22
29
24
451064D
OPERATING MANUAL
2.5.8 Starting the engine
• Before starting the engine, daily check the oil level in the
engine, hydraulic tank and fuel level in the fuel tank. Check
that there are no loosened, worn or missing parts on the
machine.
Start the engine only from the driver’s stand! Use the
alarm horn to signal the engine starting and check that
nobody is endangered by starting the engine!
Start-up procedure:
• Turn on the battery disconnecter.
• Set the travel controller (8) to the neutral position – the
parking brake is activated.
• Check that the screed gas heating (13) is turned off.
• Check that the emergency switch (1) is not activated.
• Insert the key into the ignition box (11) in the position “0”
and switch over to the position “I”.
• The brake indicator lamp (23), charging (21), hydraulics op-
erating mode switch-off (29) and engine lubrication (22) will
light up on the display.
• Set the key between position “I” and “II” and the engine
glowing indicator lamp (24) will light up.
• Do not perform engine glowing for more than 15 s.
• Use the alarm horn (12) to signal that the engine is starting.
• Turn the key to position “II” to start the engine.
• The engine lubrication indicator lamp (22) and the battery
charging indicator lamp (21) will turn off.
• After the machine moving-off is completed, the brake indi-
cator lamp goes out (23).
Do not start the engine for more than 20 seconds.
Wait at least for 2 minutes before starting again.
When starting the engine at the cold condition, slowly in-
crease the engine speed for proper lubrication of bearings
and oil pressure stabilisation.
If the charging indicator lamp does not go off after start-
ing the engine, immediately remove the failure.
If the charging (21) and lubrication (22) indicator lamps do
not go off, switch off the engine and remove the failure.