Fayat Dynapac F80W, Operating Manual

Page: 55 / 198

49 F80W
OPERATING MANUAL
2.1.17 Safety precautions for electrical and
electronic equipment of the machine
• The machine is equipped with electrical wiring, components
and electronic equipment, the operation of which can be in-
terfered by external sources of electromagnetic radiation.
• This equipment is safe if operated in compliance with in-
structions given in this Operating Manual or other docu-
mentation supplied with the machine.
Please observe the following safety instructions concerning
electrical and electronic equipment of the machine:
• Check the delivered goods for any damage immediately af-
ter delivery,
• Do not use damaged parts and instruments,
• Damaged electrical wiring and sockets represent a high
safety risk and must not be used,
• In such cases, contact your local dealer or DYNAPAC. They
will provide you with new undamaged parts.
Before installation and operation of instruments, make
yourself familiar with and carefully read entire Operat-
ing Manual to these devices.
If you do not understand any part of the supplied Op-
erating Manual or the instructions are unclear to you,
contact your local dealer or DYNAPAC before putting the
machine into operation.
In order to ensure smooth operation of DYNAPAC ma-
chinery, use only original spare parts supplied by DYNA-
PAC for repairs.
DYNAPAC does not assume any liability for addition-
ally mounted equipment which is not authorised by
DYNAPAC.
DYNAPAC assumes no responsibility in cases when the
machine is operated incorrectly by not adhering to the
instructions given in this Operating Manual, which may
result in an injury or death, damage to the machine,
property or environment.
Safety precautions
Electrical installations and wiring must be connected properly
and according to data given in this Operating Manual.
Entire electrical wiring and connection components must be
have adequate current rating within the meaning of valid regu-
lations and they must meet requirements of respective national
regulations.
All devices are only intended for industrial use and tested ac-
cordingly.
Observe all instructions for control and installation of electrical
and electronic equipment according to this Operating Manual.
Observe the correct polarity of connectors.
Ensure adherence to the prescribed supply voltage.
Check electrical wiring and connections of individual parts reg-
ularly with regard to trouble-free operation of the machine.
The machine is equipped with fuses, which protect electrical
and electronic equipment of the machine from short circuit.
Observe prescribed values of individual fuses according to this
Operating Manual or other documentation supplied with the
machine.
Electrical and electronic equipment of the machine is not in-
tended for operation in explosive environments.
Before starting works on electrical and electronic equipment of
the machine when removing defects, always disconnect elec-
trical wiring of the machine and instruments from the battery
using a disconnecter. Failure to adhere to these instructions ex-
poses you to a danger of injury of the machine operator and
danger of damage to electrical and electronic parts of the ma-
chine.
It is prohibited to interfere in any manner with electrical
and electronic parts of the machine. Special repairs can
only be performed by an authorised service centre.
It is prohibited to use free connectors to connect other
devices.