Fagor 8055i FL EN, Operating Manual

Page: 63 / 160

Operating manual
CNC 8055
CNC 8055i
O
PERATING
IN JO
G MODE
2.
·MC· O
PTION
S
OFT
: V02.2
X
·63·
Tool
cal
ibratio
n
Considerations for the cycle
Going into manual part centering without a probe cancels G73 (pattern rotation).
When the focus is in "1 - RECALL" type box or in a box of the X or Y coordinate, it will change the
color of its associated point in the drawing.
When selecting a circular part, it will be necessary to touch at 3 points; therefore, the screen will
show 3 points. When selecting a rectangular part, the number of points to touch will depend on
whether the centering is to be done on one or two axes and on whether the angle is to be calculated
or not.
The X and Y coordinates of the various points can be edited at any time.
When the focus is in a "1 - RECALL" type box, the screen will show a help message.
Data to be entered
Icon to select the type of part to be centered (rectangular or circular).
Icon to choose between machine coordinates and part coordinates.
Icon to select axes (only for rectangular parts).
It may be used to define whether the part is to be centered in both axes or only
in one.
Icon to preset the coordinates of a part reference point. Its possible values are:
• No preset.
• Preset at the center.
• Preset in each of the 4 corners if a rectangular part or in each of the 4 quadrants
if a circular part.
Icon to calculate pattern rotation (only for rectangular parts).
X X coordinate of the preset value.
Y Y coordinate of the preset value.
R Radius of the tool used in part centering. This data can only be entered when
presetting at one of the corners of a rectangular part.
If this value is not modified, the R data takes the radius value of the active tool.
The R value is updated every time a new tool offset "D" is executed.