Fagor 8055i FL EN, Operating Manual

Page: 147 / 160

CNC 8055
CNC 8055i
·MC· O
PTION
S
OFT
: V02.2
X
6
·147·
EXECUTION AND SIMULATION
The simulation may be used to graphically show a part-program or an operation with the data used
to define it. This way, the simulation may be used to check the part-program or the operation before
executing it or saving it and, therefore, correct or modify its data.
It is possible to simulate or execute:
• An operation or Cycle.
• A part-program.
• An operation saved as part of a part-program.
Selecting a program for simulation or execution
When selecting a part-program or operation saved as part of a part-program for simulation or
execution, the CNC selects that part-program and shows it highlighted next to the green "start"
symbol in the top center window.
When the top center window shows the part-program selected next to the green "start" symbol, the
CNC acts as follows:
• If [START] is pressed, the CNC executes the part-program that is selected.
• If [CLEAR] is pressed, the CNC de-selects the part-program and removes it from the top center
window.
It is possible to execute or simulate a part-program or any operation. The simulation or
execution may be done from beginning to end or step by step by pressing the [SINGLE]
key.