Fagor 8055i FL EN, Operating Manual

Page: 69 / 160

Operating manual
CNC 8055
CNC 8055i
O
PERATING
IN JO
G MODE
2.
·MC· O
PTION
S
OFT
: V02.2
X
·69·
ISO ma
nag
ement
2.10 ISO management
Access to the MDI mode or the ISO mode.
The ISO key may be used to access the MDI mode or the ISO mode.
To access the MDI mode, the CNC must be in jog mode and the ISO key must be pressed. The CNC
will show a window at the bottom of the standard (or special) screen.
In this window, it is possible to edit a block in ISO code and then execute it, like in MDI in M mode.
Displaying the last 10 MDI instructions.
From the MDI mode, pressing the [UP ARROW] or [DOWN ARROW] key opens a window that shows
the last 10 instructions that have been executed. This window resizes itself to fit the number of
instructions that have been saved.
To execute or modify an MDI line that has been executed earlier, proceed as follows:
• Go into MDI mode.
• Press the [UP ARROW] or [DOWN ARROW] key to open the window that shows the last MDI
instructions (up to 10).
• Use the [UP ARROW] or [DOWN ARROW] key to select the desired instruction.

Press [START] to execute the selected instruction.

Press [ENTER] to modify the selected instruction. Once the instruction has been modified,
press [START] to execute it.
Considerations.
• An MDI instruction is saved only if it is correct and if it is not the same as the previous one on
the list.
• The instructions are kept saved even after turning the unit off.
Generating an ISO-coded program
In the conversational mode of the CNC, it is possible to generate an ISO-coded program from an
operation (cycle) or on a part-program. See
"6.5 Graphic representation" on page 154.