Fagor 8055i FL EN, Operating Manual

Page: 65 / 160

Operating manual
CNC 8055
CNC 8055i
O
PERATING
IN JO
G MODE
2.
·MC· O
PTION
S
OFT
: V02.2
X
·65·
Tool
cal
ibratio
n
2.7.5 Tabletop probe calibration (level 4)
The new tabletop probe calibration cycle level 4 makes probe calibration easier. This reduces
machine preparation time.
The tool used for calibration must properly calibrated in radius and length.
Data to be entered
[ T ] Tool number
It defines the number of the tool used to calibrate the probe. If not programmed or programmed with
a 0 value, the CNC will display the corresponding error message.
[ D ] Tool offset number
It defines the tool offset number. If not programmed, it assumes the offset number assigned to T
in the tool table.
[ Ds ] Approach distance
Probe approaching distance in each probing movement. If not programmed or programmed with
a 0 value, the CNC will display the corresponding error message.
[ Dr ] Withdrawal distance
Distance the tool retracts after touching the probe to take the measurement. If not programmed or
programmed with a 0 value, the CNC will display the corresponding error message.
[ Fs ] Searching feedrate
Probe searching feedrate. If not programmed or programmed with a 0 value, the CNC will display
the corresponding error message.
[ F ] Measuring feedrate
Measuring feedrate. If not programmed or programmed with a 0 value, the CNC will display the
corresponding error message.
Type of calibration
Z
Y
X
Ds
Ds
It indicates whether the calibration is simple or double.
• Single calibration: the calibration is carried out in the 4 quadrants of the probe
with the spindle that holds the tool oriented at 0º.
• Double calibration: the calibration is carried out twice in the 4 quadrants of the
probe, one with the spindle positioned at 0º and the other with the spindle
positioned at 180º. This prevents tool eccentricity errors.