Fagor 8055i FL EN, Operating Manual

Page: 106 / 160

·106·
Operating manual
CNC 8055
CNC 8055i
3.
WORKING
WITH OPERATIONS OR
CYCLES
·MC· O
PTION
S
OFT
: V02.2
X
Boring
o
peratio
n
3.9.1 Definition of data
Coordinates of the machining point.
The coordinates are defined one by one. After placing the cursor on the coordinates of the axes to
be defined, the value is entered in one of the following ways.
• Entering the value manually. Key in the desired value and press [ENTER].
• Assign the current machine position.
Jog the axis with the handwheel or the JOG keys up to the desired point. Press [RECALL] so
the selected data assumes the value shown in the top right window and press [ENTER].
The top right window shows the tool position at all times.
Machining conditions in Z (Zs, Z, P, I, t).
The machining conditions are defined one by one.
• The Zs and Z values are defined as the coordinates of the machining point.
• To define the rest of the values (P, t), go to the corresponding window, key in the desired value
and press [ENTER].
Exit type at level 1.
The exit movement may be done in two ways:
Data for quail orientation and retraction (

s, Dx, Dy).
These data are defined one by one. Place the cursor in the corresponding window, key in the desired
value and press [ENTER].
It first orients the quail, it then moves back in XY and finally goes up in rapid (G00) with the spindle
stopped.
To select the type of exit, place the cursor over this icon and press the two-color key.
At machining feedrate (G01) and with the spindle turning.
In rapid (G00) and with the spindle stopped.