Fagor 8055i FL EN, Operating Manual

Page: 82 / 160

·82·
Operating manual
CNC 8055
CNC 8055i
3.
WORKING
WITH OPERATIONS OR
CYCLES
·MC· O
PTION
S
OFT
: V02.2
X
Profile
mil
ling
o
peratio
n
3.3.2 Profile definition (level 2)
Defining the profile program.
The profile program may be defined as follows.
• Key in the profile program number directly.
If the "profile program" is known, key in the program number and press [ENTER].
• Access the "profile programs" to select one of them.
Press the [

] key. The canned cycle will show a window with the profile programs currently
defined. Use the [

] and [

] keys to move around this window. After positioning the cursor on
the desired program, press [ENTER].
To exit this window without selecting any program, use the [

] y [

] keys.
Editing a new profile program.
To edit a new profile program, key in the program number (between 0 and 999) and press [RECALL].
The CNC will show the window for the profile editor (see operating manual).
After editing the profile, the CNC requests the comment to be associated with the "Profile program"
that has been edited. Enter the desired comment and press [ENTER]. If no comment is desired,
press [ESC].
Copying a profile program.
Press the [

] key. The canned cycle will show the profile programs currently defined. Place the
cursor on the profile program to be copied and press [P.PROG]. The CNC requests the number of
the new profile and it allows changing its comment. If the number entered is the same as that of
an existing profile, the CNC requests confirmation to replace it.
Modify an already existing "Profile program".
To modify a profile program, key in the program number and press [RECALL]. The CNC will show,
in the window for the profile editor, the profile that is currently defined.
With this profile, the following actions are possible:
• Add new items at the end of the present profile.
• Modifying the data of any element.
• Modify or include chamfers, rounded corners, etc.
• Deleting elements of the profile.
Deleting an existing profile program.
Press the [

] key. The canned cycle will show the profile programs currently defined. Place the
cursor on the profile program to be deleted and press [CLEAR]. The CNC requests confirmation.
The profile programs can also be accessed in the "M" mode because the CNC saves them internally
as P997xxx.
Example: Profile program 123 is internally saved as P997123.
When saving a part-program that contains a level-2 profile cycle into an external device, PC, floppy
drive, etc. also save its associated profile program P997xxx.
i