Fagor 8055i FL EN, Operating Manual

Page: 89 / 160

Operating manual
CNC 8055
CNC 8055i
WORKING
WITH OPERATIONS OR
CYCLES
3.
·MC· O
PTION
S
OFT
: V02.2
X
·89·
P
o
cket cycle with a profile
3.5.1 Definition of data
Machining conditions in Z (Zs, Z).
To define the values (Zs and Z), after going to the corresponding window, the value is entered in
one of the following ways.
• Entering the value manually. Key in the desired value and press [ENTER].
• Assign the current machine position.
Jog the axis with the handwheel or the JOG keys up to the desired point. Press [RECALL] so
the selected data assumes the value shown in the top right window and press [ENTER].
The top right window shows the tool position at all times.
Machining conditions in Z (P, Fz, I, I1, I2).
The machining conditions are defined one by one.
• To define the values (P, Fz, I, I1, I2), go to the corresponding window, key in the desired value
and press [ENTER].
If the penetration step is programmed with a positive sign (I+), the cycle recalculates the step
so all the penetrations are identical, this being equal to or less than the one programmed. If
programmed with a negative sign (I-), the cycle is machined with the given pass (step) except
the last pass that machines the rest.
Milling pass (

) and finishing pass (

).
Place the cursor in the corresponding window, roughing or finishing operation, key in the desired
value and press [ENTER].
Sideways penetration angle (

,

).
Place the cursor in the corresponding window, roughing or finishing operation, key in the desired
value and press [ENTER].
Finishing stock on the side walls (

) and at the bottom (

z).
Place the cursor in the corresponding window, finishing operation, key in the desired value and press
[ENTER].
Finishing tool tip radius (R).
Place the cursor in the corresponding window, finishing operation, key in the desired value and press
[ENTER].
Direction of the finishing passes on the walls.
To select the direction of the finishing passes on the walls, place the cursor
over this icon and press the two-color key.