Fagor 8055i FL EN, Operating Manual

Page: 62 / 160

·62·
Operating manual
CNC 8055
CNC 8055i
2.
O
PERATING
IN JO
G MODE
·MC· O
PTION
S
OFT
: V02.2
X
Tool
cal
ibratio
n
MANUAL PART CENTERING WITHOUT A PROBE.
This cycle, without using a probe, minimizes the preparation time of a part calculating the real
coordinates of the center and the inclination of the part.
To calculate the center of the part, the part must be touched on its sides.
Rectangular or circular part centering without a probe.
T: Probe's tool number. If not programmed or programmed with a 0 value, it generates the
corresponding error message.
D: Tool offset number. If not programmed, it assumes the offset number assigned to T in
the tool table.
Fs: Part searching probing feedrate. If not programmed or programmed with a 0 value, it
generates the corresponding error message.
F: Probing feedrate for measuring. If not programmed or programmed with a 0 value, it
generates the corresponding error message.
Fa: Probe positioning feedrate to the starting points of the part searching probing
movements. If not programmed, it is done in rapid (G0).
Icon to preset the coordinates of a part reference point. Its possible values are:
• No preset.
• Preset at the center.
• Preset in each of the 4 corners if a rectangular part or in each of the 4 quadrants if
a circular part.
ORGX: X coordinate of the preset value. If not programmed, it assumes 0.
ORGY: Y coordinate of the preset value. If not programmed, it assumes 0.
ORGZ: If part surface measuring has been selected, Z coordinate of the preset value. If not
programmed, it assumes 0.
Icon to apply or not the measured coordinate (pattern) rotation. Only for rectangular
parts.
Z
2
1
Y
X
3
4
5
(Xc, Yc)
Z
Y
X
1
2
3
(Xc, Yc)