Fagor 8025 T CNC, Operating Manual

Page: 57 / 309

32 8025/8030 CNC OPERATING MANUAL
3.5.4. Jogging the axes
3.5.4.1. Continuous movement
- Front panel (M.F.O.) switch in any position of the % FEEDRATE zone.
- According to the axis and the direction in which it is desired to move, the JOG key
corresponding to this axis must be pressed:
- As established by means of the machine-parameter:
. (P12=Y). Releasing the key, the movement is stopped.
. (P12=N). Two possibilities:
- Press to stop the movement.
or.
- Press another JOG key.
To reverse or transfer the movement of one axis to another .
Atention:
On selecting the JOG operating mode the feedrate F0 remains selected. If
another feed is not entered later, the axes move at the % of F indicated by the
switch on the front.
Rapid feed of an axis in JOG mode can be obtained while pressing the
RAPID FEED key.
3.5.4.2. Incremental movement
- Front panel M.F.O. switch in the JOG zone.
- Press any of the JOG keys:
The axis will move in the direction chosen, a distance equal to that indicated on the knob
position:
Atention:
a) On selecting the JOG operating mode the feedrate F0 remains selected. If
another feed is not entered later, the axes move at the % of F indicated by the
switch on the front.
Rapid feed of an axis in JOG mode can be obtained while pressing the
RAPID FEED key.
b) The positions of the knob are 1,10,100,1000 and 10000, and indicate the value
of the movement in microns or in 0.0001 inches.