Fagor 8025 T CNC, Operating Manual

Page: 245 / 309

8025/8030 CNC PROGRAMMING MANUAL 131
12.3.1. Identification of a parametric subroutine
A parametric subroutine always starts by G23.
The structure of the first block is:
N4 G23 N2
N4 : Block number
G23 : Defines the start of a parametric subroutine
N2 : It identifies the parametric subroutine (it may be any number between 00 and 99).
Atention:
Two parametric subroutines with the same number cannot co- exist in the
CNC’s memory, even if they are included in different programs. Two
subroutines one standard the other parametric can be identified by the
same number.
A parametric subroutine must necessarily end with a block of the format: N4 G24.
N4 : Block number
G24 : It defines the end of a subroutine (standard or parametric).
No additional information can be programmed in this block.