Fagor 8025 T CNC, Operating Manual

Page: 67 / 309

42 8025/8030 CNC OPERATING MANUAL
3.6.5. Display and search of memorized subroutines in the CNC memory
- By pressing [STANDARD SUBROUTINES DIRECTORY] or [PARAMETER
SUBROUTINES DIRECTORY] all the subroutines, standard or parametric, recorded
in the CNC memory are displayed.
- To find out which programs contain the subroutines displayed on the screen, key in the
subroutine number and press RECALL.
The number of the program where this subroutine is found will appear on screen.
To repeat the process for another subroutine, press DELETE or the [SUBRTS] key and
repeat the previous sequence.
3.6.6. Selection of a program
- If the number of the required program is the one which appears on the screen when the
EDIT operating mode is selected, to obtain it just press [CONTINUE].
- If a different program is wanted :
- Press the [PROGRAM SELECTION] key.
- Key in the program number.
- Press [CONTINUE]. The program selected will appear
on the screen.
3.6.7. Creating a program
If there is a program in the CNC’s memory with the same number as the one to be recorded,
there are two methods for recording the new program:
- Completely erase the existing program.
- Not to erase it and write it block by block (as described further on) over the existing
program, taking care to assign the same numbering as the previously recorded blocks
to the blocks being written.If there is no other program in memory with the same
number, proceed as follows: