Fagor 8025 T CNC, Operating Manual

Page: 74 / 309

8025/8030 CNC OPERATING MANUAL 49
c) The program selected exists on the tape and not in the control’s memory.
During this process the screen will display: RECEIVING
The transfer is carried out normally.
- If in the program being read there is any erroneous block number (example,
Nxxxxx) the screen will display:
PROGRAM NUMBER: P —— RECEIVED
INCORRECT DATA RECEIVED
N xxxxx
In this case, only the part of the program up to the erroneous block is memorized.
It is recommended to delete the whole program.
- If the numbering of the blocks of the program transferred is correct:
PROGRAM NUMBER: P —— RECEIVED
That means that the CNC carries out a syntactic test of the program. If there is any
programming error the relevant error code and the affected block are displayed and
the program is loaded completely.
d) If the part program memory is locked, or the machine- parameters memory in case
of (P99999), the status in section 3.7.1. is re-established.
3.7.2.1. Transmission errors
- If during transmission TRANSMISSION ERROR appears on the screen, this indicates
that the transmission is not correct.
- If during transmission INCORRECT DATA RECEIVED
appears on the screen.
This indicates that there is an incorrect character on the tape, or a non permitted block
number has been written.
Atention:
The lid of the cassette recorder should be open when turning the unit ON/
OFF to prevent tape damage.