Fagor 8025 T CNC, Operating Manual

Page: 61 / 309

36 8025/8030 CNC OPERATING MANUAL
3.5.10. Handwheel operation
When an electronic handwheel is fitted, with this option the axes can, one at a time, be
moved manually. For this:
- Select the JOG operation mode.
- Turn the front knob to one of the positions.
- Press any of the two JOG keys which correspond to the axis to be moved by the
Handwheel. If a FAGOR Handwheel (mod 100 P) is used, the axis can also be selected
by means of the built-in selector button; the relevant axis will be highlighted on the
CRT.
- Turn the Handwheel, the axis will move according to the setting of the relevant machine-
parameter multiplied by the factor selected with the switch (X1,X10,X100).
It should be borne in mind that if we wish to move an axis at a speed of over G00
corresponding to this axis, the CNC will assume this as maximum, ignoring additional
pulses. In this way the generation of following errors is avoided.
To change the axis being jogged:
- Press any of the two JOG keys of the new axis or the axis selector button if a FAGOR
Handwheel (mod 100 P) is used.
- Turn the Handwheel.
To end the Handwheel operation.
- Turn the M.F.O. switch to any other position or press the STOP key or keep the axis
selector button pressed until the CRT stops displaying (blinking) the selected axis, if a
FAGOR Handwheel (mod 100 P) is used.