Fagor 8025 T CNC, Operating Manual

Page: 119 / 309

8025/8030 CNC PROGRAMMING MANUAL 5
3. PROGRAM FORMAT
The CNC can be programmed in millimeters or in inches.
Metric format (in mm):
P(%)5 N4 G2 X+/-4.3 Z+/-4.3 F5.5 S4 T2.2 M2
Format in inches:
P(%)5 N4 G2 X+/-3.4 Z+/-3.4 F5.5 S4 T2.2 M2
+/- 4.3 Means that a positive or negative figure with up to four digits to the left
of the decimal point and three to the right may be programmed.
+/- 3.4 Means that a positive or negative figure with up to four digits to the left
of the decimal point and three to the right may be programmed.
4 Means that only a positive integer (no decimals) of up to four digits may
be programmed.
2.2 A positive value of up to two digits to the left and two to the right of the
decimal point may be programmed.
Throughout this manual the format corresponding to each function will be enumerated, as
well as the meaning of the different parameters used.
3.1. PARAMETRIC PROGRAMMING
It is also possible to program in a block any function by parameters, except the program
number, the block number, G functions, in the same block of another piece of data, such
as: G4K..;G22N..;G25N.. etc in such a way that , when executing the block, the function
takes the current value of the parameter. Combinations of fixed values and parameters can
be programmed in the same block, e.g.:
N4 GP36 X37.5 ZP13 FP10 S1500 TP4.P4 MP2
The CNC has 255 arithmetic parameters (P00/P254). (See chapter 13 of this manual
regarding Parametric Programming).