Fagor 8025 T CNC, Operating Manual

Page: 51 / 309

26 8025/8030 CNC OPERATING MANUAL
3.4. MODE 4: DRY RUN
This operating mode is used for testing a program in a dry run before producing the first part.
3.4.1. Execution of a program
The execution of a program requires the following steps:
3.4.1.1. Selection of the operating mode DRY RUN (4)
- Press OP MODE
- Press key 4. The screen will display:
DRY RUN
0 - G FUNCTIONS
1 - G,S,T,M FUNCTIONS
2 - RAPID MOVE
3 - THEORETICAL PATH
0 - G FUNCTIONS
The CNC will only execute the programmed G functions.
1 - G,S,T,M FUNCTIONS
The CNC will only execute the programmed G,S,T,M functions.
2 - RAPID TRAVERSE
The CNC will execute the program completely. The movements are executed at max.
programmable Feedrate (F0) regardless of the F’s programmed.
The Feedrate Override allows the % feed to be varied.
It should be borne in mind that if parameters P712, P713, P714, P724 are active too,
acceleration/deceleration will be applied to F0, avoiding the generation of following errors.
3 - THEORETICAL PATH
The CNC will execute the program without moving the axes and without taking tool
compensation into account.