Fagor 8025 T CNC, Operating Manual

Page: 52 / 309

8025/8030 CNC OPERATING MANUAL 27
3.4.1.1.1. Selection of execution mode
- Key-in the desired number.
- The selected line will appear on the screen completed.
FINAL BLOCK:
N.
Will be displayed at the bottom of the screen.
There are two possibilities:
a) If it is desired to run the entire program selected.
- Press ENTER
b) If it is desired to run the program as far as a specific block:
- Key-in the number of the block whose execution in
Dry Run mode is desired including the execution of this block. If this block includes the
definition in a canned cycle, it will only be executed until it is positioned at the starting
point in the cycle.
- Press ENTER
- The letter P will appear on the screen.
- Enter the number of the program where the final block is located and then press
ENTER.
If the number of the program is the one already selected, just press ENTER.
- The symbol # will be displayed.
- After this symbol, enter the number of times that the previous block must be repeated.
(Maximum value 9999.)
- Finally press ENTER.
In both cases, a) and b), the screen will display the same information as in AUTOMATIC and
SINGLE BLOCK.