Fagor 8025 T CNC, Operating Manual

Page: 68 / 309

8025/8030 CNC OPERATING MANUAL 43
3.6.7.1. Unassisted programming
Format of a block
(dimensions in millimeters)
N4 G2 X+/-4.3 Z+/-4.3 F5.4 S4 T2.2 M2 (in this order)
(dimensions in inches)
N4 G2 X+/-3.4 Z+/-3.4 F5.5 S4 T2.2 M2 (in this order)
Programming:
The CNC automatically numbers the blocks in multiples of 10. If a different block number
is desired, press CL and then:
- Key in the block number. It will appear on the lower left-hand side of the screen. The
blocks may not be correlative.
- If a normal conditional block is desired, after keying in the block number, press
(decimal point) and if a special conditional block is required press again.
Write the G functions and coordinate values respecting the programming format.
- Press the F key and key in the feedrate value.
- Press the S key and key in the spindle speed.
- Press the T key and key in the tool number.
- Press the M key and key in the number of the auxiliary function wanted. Up to a
maximum or 7 may be programmed.
- Finally it is possible to write a COMMENT which must be within brackets (COM-
MENT).
- If the block is correct, press ENTER. The CNC accepts the block as a program block.
Refer to the PROGRAMMING MANUAL for incompatibilities when programming
various functions.