Fagor 8025 T CNC, Operating Manual

Page: 59 / 309

34 8025/8030 CNC OPERATING MANUAL
3.5.6. Measurement and loading of the tool dimensions in the offset table.
Once the JOG mode has been chosen, the tool dimensions can be measured and introduced into
the table, by using a part with known dimensions. For this, machine parameter P806 will be
assigned a value of 0. The sequence to be executed is as follows:
. Press the function key [TOOL MEASUREMENT]
. Press X.
. Key in the dimension of the part according to the X axis. This value will be in radii or
diameters, depending on how the machine is working.
. Press ENTER.
. Press Z.
. Key in the part dimension according to the Z axis.
. Press ENTER.
. Key in the desired tool number (T2.2).
. Press START.
. Move the X axis with the manual controls, until the part is touched.
. Press X.
. Press [LOAD]. At that moment the new X dimension of the tool calculated by the control
becomes active, due to which the dimension displayed on the X axis must be the same as the
one introduced as the radius or diameter of the part.
. Move the Z axis with the manual controls, until the part is touched.
. Press Z.
. Press [LOAD]. At that moment the new Z dimension of the tool calculated by the control
becomes active, due to which the dimension displayed on the Z axis must be the same as the
one introduced as the radius or diameter of the part.
. If you want to do the same with another tool, it is necessary to begin once more by keying
in the new tool (T2.2); the rest of the operation is the same as the first tool.
. To go on to work in the normal way in the MANUAL mode, the [TOOL MEASUREMENT]
key must be pressed.