Fagor 8025 T CNC, Operating Manual

Page: 190 / 309

76 8025/8030 CNC PROGRAMMING MANUAL
6.26.5. G75 N2. Probing canned cycles
The TS model offers several probing canned cycles to measure tool and part dimensions.
The programming format is as follows:
G75 N* P? = K? P? = K?
The figure after N defines the probing cycle to be executed.
The CNC’s probing canned cycles are:
N0: Tool calibration
N1: Probe calibration
N2: Part measurement in X axis
N3: Part measurement in Z axis
N4: Part measurement in X axis and tool correction in X axis
N5: Part measurement in Z axis and tool correction in Z axis
After N*, the calling parameters P?=K? must be programmed.
P1: Theoretical X value
P2: Theoretical Z value
P3: Safety distance
P4: Probing feedrate
P5: Tolerance
P6: Table number of the tool to be calibrated
GENERAL CONSIDERATIONS
. If any parameter that corresponds to a cycle is not programmed, the CNC will assume
the latest value assigned to that parameter. The cycles do not modified the calling
parameters (which can be used in later cycles) but do alter the contents of parameters
P70 to P99.
. P1 must be programmed in radius or diameters depending on the setting of machine
parameter P11.
. Parameters P3 and P5 must always be programmed in radius.
. Parameter P3 must be greater than zero.
. Parameter P5 must be equal or greater than zero.
Error 3 will be issued if one of these two conditions are not met.