Fagor 8025 T CNC, Operating Manual

Page: 206 / 309

92 8025/8030 CNC PROGRAMMING MANUAL
and if in block N20 the parameter values are: P90=1250 and P55=2500, and in block N40,
P2=14.853 and P5=154.37, the CNC will generate the following program P00345.
N100 G1 X78.35 F500 M3
N101 X14.853 Z154.37 M7
N102 G0X14 Z20 M5
It is necessary to program all five digits of the program number in blocks of type G76 P5
or G76 N5
The CNC must be in DNC ON (operating mode 7) in order to load the new program into
a computer (see DNC manual).
If the number of the program to be generated exists already in memory (e.g. P12345) it
must be in the last position of the program map; but if G76 P12345 is executed, the old
program is erased and the new one can be generated.
When the program number exists in memory but is not the last one in the memory map,
the CNC will issue error 56.
Atention:
When a program is edited it goes to the last position in memory map and
when it is executed it goes to the first position.
When a program is being generated, another program cannot be generated
until the generation of the previous one is cancelled by means of
M2,M30,RESET or EMERGENCY.
Some of the applications of the G76 function are, for example, the
creation of a program after the calculation of a trajectory by means of a
parametric program, or the DIGITIZING of a model with a measuring
probe (G75) generating a point-to-point program as large as desired.