Fagor 8025 T CNC, Operating Manual

Page: 124 / 309

10 8025/8030 CNC PROGRAMMING MANUAL
Functions G14, G15, G16, G75 N2 and G76 are only available on the model TS CNC
model.
Modal means that once the G functions have been programmed they remain active until
cancelled by another G which is incompatible or by M02,M30,EMERGENCY or
RESET.
The G functions marked * are those which the CNC assumes on being turned on or after
executing M02 or M30 or after an EMERGENCY or RESET. Whether G05 or G07 is
assumed will depend on the value assigned to P613(5).
All the G’s required may be programmed in any order in the same block, except G14, G15,
G16, G20, G21, G22, G23, G24, G25, G26, G27, G28, G29, G30, G31, G32, G50, G52,
G53, G59, G72, G73, G74 and G92 which have to be alone in a block. If incompatible G
functions are programmed in the same block, the CNC assumes the one programmed last.