Fagor 8025 T CNC, Operating Manual

Page: 88 / 309

8025/8030 CNC OPERATING MANUAL 63
3.10.1. Display area definition
Prior to the representation of graphics on the CRT, the display area must be defined before
the program is run. To do this, after selecting the desired operation mode.
- Press the [GRAPHICS] key.
- Press the [DEFINE AREA-V] key.
Next, the values of the coordinates X, Z must be keyed in from the point at which it is
required that it appear in the center of the screen and the value of the width we want it to
represent. After keying in each value, the ENTER key must be pressed.
The definition of the display area must be made every time the CNC is switched on, if it
is required to use the graphic representation feature.
Then, execute the program; the position and size of the graphic will depend on the values
given to the center point and width. The coordinate values of the point being displayed are
shown at the top of the CRT. The value of the width is displayed at the bottom.
When a program is being run in the DRY RUN operating mode, it is possible to vary the
speed the diagram is drawn on the screen, by means of the FEED RATE switch.