Creating and Starting a Test Case
Ethernet and Fibre Channel Application
77
EtherSAM (Y.1564) Test Case
4c.
Select the
Frame Format
. Choices are
Ethernet II
and
802.3 SNAP
. For
802.3 SNAP
, select the Organizationally Unique
Identifier (OUI). Refer to
information.
4d.
Select the
PBB-TE
check box to enable the capability to generate
and analyze streams with PBB-TE data traffic including
configuration of B-MAC (source and destination), B-VLAN and
I-tag, and to filter received traffic by any of these fields.
PBB-TE
is
a software option and needs to be enabled to give access to the
PBB-TE testing capability (refer to
PBB-TE is not available when the
MPLS
check box is selected.
PBB-TE Interface configuration
on page 483 for more
information.
Select the
MPLS
check box to enable the capability to generate
and analyze streams with up to two layers of MPLS labels and to
filter received traffic by MPLS label or COS.
MPLS
is a software
option and needs to be enabled to give access to the MPLS testing
capability (refer to
available when the
PBB-TE
check box is selected. Refer to
on page 499 for more information.
TX
and
RX
:
Allows the selection of the interface MPLS TX and RX labels (
0
to
1048575
). The default label value is
16
for both TX and RX. The
TX and RX labels are available when the
MPLS
check box is
selected. Refer to
on page 150 for more information.
4e.
Set the
IP Version
(IPv4 or IPv6).
IP Version
is only available
when the IPv6 software option (SK-IPV6) is enabled.
4f.
For IPv4, select the
Automatic IP Address
check box to
dynamically obtain an IP address from a DHCP (Dynamic Host
Configuration Protocol) server or set the source and destination IP
addresses,
Subnet Mask
, and the
Default Gateway
on page 485 for more information.
