Creating and Starting a Test Case
100
IQS-8500 Series and IQS-8120NGE/8130NGE
Ethernet BERT Test Case
5.
Traffic stream
configuration:
Only
Frame Size
and
Maximum
Rate are
configurable with
Framed Layer 1.
5a.
For IPv4, select the
Automatic IP
Address
check box
to dynamically
obtain an IP
address from a
DHCP (Dynamic Host Configuration Protocol) server or set the
source and destination IP addresses,
Subnet Mask
, and the
Default Gateway
. Refer to
more information.
5b.
For IPv6, set the destination IP address and if required, press the
IPv6 Config
button for additional IPv6 settings. Refer to
on page 487 for more information.
5c.
If required, set the network source MAC Address. Select the
Resolve MAC Address
check box or set the destination MAC
address. Refer to
on page 220 for more information.
5d.
Select the
Frame Format
. Choices are
Ethernet II
and
802.3 SNAP
. Refer to
information.
5e.
Select the Enable
VLAN
check box when required and set the
number of stacked VLAN and its parameters (
VLAN Config
button). For more information on
VLAN
refer to
5f.
Enter the
Frame Size
. For more information on
Frame Size
refer
to
Size
on page 211.
