Creating and Starting a Test Case
98
IQS-8500 Series and IQS-8120NGE/8130NGE
Ethernet BERT Test Case
4.
Framing configuration:
4a.
Select the test framing
mode.
Ethernet Unframed
: Consists in sending a frame without EOF
(End Of Frame). Ethernet Unframed is only available for optical
interfaces excluding 10Gig-E WAN.
Enable Sync
disabled:
Enable Sync
enabled:
Ethernet Framed Layer 1
: Consists in sending a frame of x bytes
specified from the frame size field; refer to frame
Size
on page
211 for more information. This framing type allows the connection
to any interface that complies with 802.3 Ethernet PHY or DWDM
fibre.
Ethernet Framed Layer 2
: Consists in sending a frame of x bytes
specified from the frame size field; refer to frame
Size
on page
211 for more information. This framing type allows the connection
to any EtherType interface (10/100/1000Mbps) or Ethernet
network (10GigE) that complies with 802.3 Ethernet Layer 2 (valid
MAC address, type/length, and FCS bytes).
Note:
For Layer 3 and Layer 4, choose
Ethernet Framed Layer 2
and refer to
Stream Generation Tabs - Overview
once the test is created.
Ethernet II
802.3 SNAP
