ETC Emphasis Lighting Control System, User Manual

Page: 248 / 292

238 Emphasis Console v1.4.0 User Manual
Express LPC Installation and Configuration
The Express LPC may be mounted in a 19-inch equipment rack, or may be placed on or
mounted above or below a stable, horizontal surface, or may be mounted to a vertical
surface. The LPC is provided with rubber feet (use these if your LPC is portable or surface-
mounted) and hardware for rack- and surface-mounting.
All connections except RFU are made on the rear panel of the unit. All of the connections
available on the full Facepanel are available on the LPC. See Express LPC Rear Panel,
page 274 for a diagram of the LPC connections.
See Installation Guidelines, page 9 for general instructions for setting up your Emphasis
Control System.
Rack-mount Installation
Install Express LPC in a 19-inch equipment rack:
Step 1: Remove all mounting hardware from the plastic bag.
Step 2: Place one black washer on each of the eight 10-32x1/2” screws.
Step 3: Attach the two L-brackets to the side panels of the LPC using three 6-32x1/4”
flathead screws each. Choose the bracket holes that position the bracket flush
with the front panel.
Step 4: Secure the two rear brackets to the side panels of the LPC using two 6-32x1/4”
flathead screws each, orienting the brackets as shown above.
Step 5: Check the equipment rack for threaded mounting holes. If the rack holes are not
threaded, use the small black clips provided with the LPC. Slide the black clips
over the rack mounting holes so that you can thread the screws into them.
Step 6: Fit the LPC through the front of the equipment rack and position over the
mounting holes. The L-brackets should be on the outside of the rack.
Step 7: Secure the LPC to the front of the rack using four 10-32x1/2” screws and
washers as shown above.Keep the rear of the LPC supported to avoid bending
the front brackets.
(5) 6-32 x 1/4” flathead
(4) 10-32 x 1/2” Phillips
(with washers)
(4) 10-32 x 3/8” Phillips
(4) 10-32 x 1/2” Phillips
(with washers)
(5) 6-32 x 1/4” flathead