ETC Emphasis Lighting Control System, User Manual

Page: 170 / 292

160 Emphasis Console v1.4.0 User Manual
Edit an existing macro in the Macro Editing display:
Step 1: Press [Setup] [6] [Enter] to display the Macro List.
Step 2: Type the macro number on the numeric keypad and press [Enter] .
N o t e :
You can also select macros for viewing and editing using the mouse in Emphasis
Visualization. Simply click the macro number or label in the Console Screens, Console
or Monitor layout. You can also click the command to be edited.
Step 3: Press [S1 - Edit Macro] to access the Macro Editing display. If there are
commands in the macro already, the first command is highlighted in yellow.
Step 4: Press facepanel keys to insert commands before the selected (yellow)
command.
Step 5: To select a command to edit, press:
• Right-arrow [
t
] to move forward through the recorded commands one by
one.
• Left-arrow [
s
] to move backward through the recorded commands one by
one.
• Down-arrow [
v
] to move forward through the recorded commands in ten-
command increments. If there are less than ten commands, this jumps to the
end of the list.
• Up-arrow [
u
] to move backward through the recorded commands in ten-
command increments. If there are less than ten commands, this jumps to the
beginning of the list.
Step 6: Press:
•
Facepanel keys, or use the Key List, to insert commands before the selected
(yellow) command.
• [S2 - Replace] to replace the selected command with a new command.
• [S3 - Delete Entry] to remove the command from the macro.
Step 7: When done, press [Enter Macro] to record your changes.