Emerson Vilter Vission 20/20, Operation And Service Manual

Page: 306 / 338

D - 8
Appendix D • Vission 20/20 Communication Table
Vission 20/20 • Operation and Service Manual • Emerson • 35391SC 2.7
Vilter
TM
Address
Ethernet
IP
Address
Modbus
Address
Command Name
Data
Type
Value Mode
Lower
Range
Higher
Range
111 N55:17 40417 Runtime Hours (1-999) INT Read
112 N55:18 40418 Remote Lock Mode INT 0 = OFF, 1 = ON Read
Commands
113 N56:0 40500 Alarm Reset INT 1 = Perform Reset Read-Write
114 N56:1 40501 Active Remote Control ENUM "0 = None (Local)
1 = Direct I/O
2 = Serial
3 = Ethernet" Read-Write
115 N56:2 40502 Remote Capacity
Control Select ENUM "0 = Auto Capacity Control
1 = Pulse Load / Unload
2 = Hold Capacity %" Read-Write
116 N56:3 40503 Auto Capacity Control
Type ENUM "0 = Suction Pressure (if
enabled)
1 = Process Control (if
enabled)
2 = Discharge Pressure (if
enabled)" Read-Write
117 N56:4 40504 Remote Pulse Load F-INT "0 = Stop Pulse
10 = 1 Second Pulse
15 = 1.5 Second Pulse
20 = 2 Second Pulse
…
145 = 14.5 Second Pulse
150 = 15 Second Pulse" Read-Write
118 N56:5 40505 Remote Pulse Unload F-INT "0 = Stop Pulse
10 = 1 Second Pulse
15 = 1.5 Second Pulse
20 = 2 Second Pulse
...
145 = 14.5 Second Pulse
150 = 15 Second Pulse" Read-Write
119 N56:6 40506 Capacity Hold % INT 0 – 100 Read-Write
120 N56:7 40507 Active Setpoint ENUM "1 = Setpoint 1
2 = Setpoint 2 (if enabled)" Read-Write
121 N56:8 40508 Start Command INT "1 = Remote Auto
2 = Auto Sequencing" Read-
Write (See
Appendix)
122 N56:9 40509 Stop Command INT 1 = Stop Read-Write
123 N56:10 40510 Auto-Cycle Enable/
Disable INT 0 = Disable, 1 = Enable Read-Write
124 N56:11 40511 Pumpdown Enable/
Disable INT 0 = Disable, 1 = Enable Read-Write
125 N56:12 40512 Pulldown Enable/
Disable INT 0 = Disable, 1 = Enable Read-Write