© ElektroPhysik
QuintSonic 7
29 von 184
4.3 Parameter setting
Many of the screens do not represent submenus but list parameter setting options. Most of the
parameters are user adjustable. Their setting may vary according to the type of parameter. In this
section, a few examples are given to show you how to set the different types of parameters.
Your parameter selection will be highlighted in grey. Use the arrow-keys to scroll through the
options. If you scroll down over the maximum, the cursor will skip aback to the beginning. This is
for quicker setting action. The cursor does only mark your parameter option without making any
changes to it. How to reach the editing mode for changing a parameter will be explained in the
relevant sections relating to the different parameter types.
Some of the parameters cannot be changed such as “active batch” / “batch properties”. You will
quickly identify such parameters if no selection cursor is available.
4.3.1
Setting a switch parameter (Example: Backlight)
Some parameters only offer two settings such as on/ off or
enabled/disabled. This kind of parameters are referred to as “switch
parameters”.
Example: “Backlight” from the submenu “Setup\Display”.
Select “Setup” followed by “Display” and choose “Backlight”.
Press OK and the parameter will change its state.
If you press again, it will switch back, etc.
The state highlighted state is being active.