© ElektroPhysik
QuintSonic 7
155 von 184
Default setting is “Output of readings to the interface: OFF“
If you wish to output data immediately during measurement, proceed as
follows:
-
Set “Data output” to “RS232 Cable”
-
Se
t “Output of readings to the interface” to “ON”.
This setting is provided for transfer of readings for further processing e.
g. in a quality assurance or production control software.
Direct output of readings is only possible via the “RS232 Cable“ setting.
It is not available with the “Infrared IrDA” option.
The two options
-
“Transfer of readings into the statistics”
-
“Output of readings to the interface“ (Default setting: OFF)
can be enabled at the same time. This setting is only pos
sible if “Output
of readings to the interface” is set to “ON”.
If QuintSonic 7 is permanently connected to a PC, documentation of
readings is commonly made by a quality assurance or production
control software installed on a PC.
If you wish to additionally store the readings in the QuintSonic 7, it is
required to enable the “Transfer of readings into statistics”. To prevent
a memory overflow, the maximum number of readings storable in the
gauge should not be exceeded.
The setting of “Fixed point format“ determines the data format of
readings transferred via the RS232 interface.
If “Fixed point format” has been enabled, you may change the default
setting “Floating point” to “Fixed point” (e.g. when connecting a data
logger).
In the fixed point setting, all readings will be transferred as follows:
-
metric: “µm” with one decimal place
-
imperial: “mils” with two decimal places
-
decimal inch: “inch” with 4 to 5 decimal places
In the floating point format, readings will be transferred according to the
resolution (see also section 19 Technical Data).