ELABO G1-1, Operating Instructions Manual

Page: 4 / 135

4
1. INTRODUCTION
Full-electronic G1-1 HV DC-Tester
10.5.3 Fault handling Auto Test ............................................................ 78
10.5.4 Edit test plan ............................................................................... 80
10.5.5 Create test plan ........................................................................... 81
10.5.6 Delete test plan .......................................................................... 82
10.6 SETUP (DEVICE PARAMETER) ............................................................ 83
10.6.1 Pass word definition ................................................................... 85
11 TEST PARAMETERS ............................................................................. 90
11.1 PARAMETERS FOR HIGH VOLTAGE TEST ......................................... 90
11.2 PARAMETERS INSULATION RESISTANCE TEST ISO ...................... 94
11.3 TIME-STEP ............................................................................................. 98
11.4 CALCULATION OF THE IDLE TIME (HV / ISO) .................................... 99
12 OPTIONAL OUTPUTS / INPUTS ........................................................ 100
12.1 BASE SETTINGS OUTPUTS/INPUTS ................................................. 100
12.1.1 Digital Output/Input Setup ....................................................... 102
12.1.2 Analog Outputs/Inputs ............................................................ 103
12.2 ADDITIONAL DIGITAL INTERFACE OPTION G1-1 E06 .................... 105
12.3 EXPANDED DIGITAL/ANALOG INTERFACE OPTION G1-1 E07 ..... 106
12.4 CREATE PARAMETER BLOCKS ........................................................ 107
12.4.1 Digital Outputs .......................................................................... 108
12.4.2 Analog Output ........................................................................... 109
12.4.3 Digital Inputs (Input) ..................................................................111
12.4.4 Analog Inputs ............................................................................ 112
12.5 CREATE TEST PLANS (INPUT/OUTPUT) ......................................... 114
12.6 LOAD AND EXECUTE TEST PLANS (INPUT/OUTPUT) .................... 115
12.6.1 Start /execute test plan (auto- mode) ...................................... 115
12.6.1.1 Read digital input ................................................................ 116
12.6.1.2 Read analog input ................................................................ 116
12.6.1.3 Set digital output ................................................................. 117
12.6.1.4 Set analog output ................................................................ 117
12.6.2 Start /execute test plan (step mode) .........................................118
12.6.2.1 Read digital input ................................................................ 118
12.6.2.2 Read Analog Input ............................................................... 118
12.6.2.3 Set Digital Output ................................................................ 119
12.6.2.4 Set Analog Output ............................................................... 119
13 ELABO LITE-SOFTWARE ................................................................... 120
13.1 COMMANDLINE TOOL: ....................................................................... 120
13.2 FLASH-PROGRAMER FOR FIRMWARE UPDATE ........................... 120
13.3 DRIVER TEST (TREIBER TEST) ......................................................... 120
13.4 RESULT EXPLORER/MESSWERTSPEICHER AUSLESEN............... 120
13.5 RS-CONFIG / SERIAL INTERFACE RS232 ....................................... 121
13.6 TRANSLATION TOOL .......................................................................... 121
14 FAST-START-MODE ............................................................................ 122
14.1 PREREQUISITES FOR USE OF THE FAST-START MODE: .............. 122
14.2 RESTRICTIONS ON FAST-START MODE: ......................................... 122
14.3 GLOSSARY .......................................................................................... 122
14.4 STARTING POSITION: ......................................................................... 122
14.5 ACTIVATING FAST START MODE: ..................................................... 123
14.6 PARAMETERIZATION OF THE TEST: ................................................ 123
14.7 TEACHING THE UNIT: ......................................................................... 123
14.8 STARTING THE TEST: ......................................................................... 124
14.9 FAST-START-MODE VOLTAGE TIME DIAGRAM ............................... 124
14.10 PROCEEDINGS OF THE CIRCUIT: ..................................................... 124
14.11 MORE FEATURES: .............................................................................. 125
14.12 FAST-START-MODE OVERVIEW ........................................................ 125