ELABO G1-1, Operating Instructions Manual

Page: 85 / 135

85
10. MENU SYSTEM
10.6.1 Pass word definition
Passwords -
Activate and change Passwords for the levels 1, 2, 3 (as-
signments of the password steps and predefined passwords - see Chapt.
3.9). The passwords for the layers are individually set able.
Note:
For activating the menu "Settings - Password" the level-3 password
for "Settings" is necessary.
Test- level-1
• Enter the new password for Test (see chapt. 3.9).
• Accept the new password by using the "save"- button.
The new password is now active.
Parameter - level-2 / Setup - level-3
Enter the passwords for "Parameter" and Setup" in the same way
then "Measure".
main - after boot-up, the main screen is shown, see fig.
10.1.
test - after boot-up, the test screen is shown, see fig. 10.3.
Buzzer active - Buzzer On/Off.
Off - the buzzer is switched off.
On - the buzzer is active
Passed - the buzzer sounds permanent
Fault - interval sound for appr. 5 s
Short intervals - manual interruption
Medium intervals -fault during high voltage test (limit value
was exceeded)
Long intervals - interruption at time out (residual voltage
measurement, test voltage not reached, etc.)
measurement, test voltage not reached, etc.)
fault at: bonding, manual time out, mains inverse polarity,
mains supply not within tolerance.
Buzzer volume - Loudness of the buzzer in percent.
Fig. 10.39: Setup part 2
buzzer active ............
pass words ..................
device information ......
hood pulse ................
off
indicate
change
level2
Setup
Full-electronic G1-1 HV DC-Tester