114
12. INPUT/OUTPUT TEST STEPS
12.5 Create Test plans (Input/Output)
Read and Set of inputs/outputs are only possible in test plan sequences
on automatic test runs. For this, input / output parameter blocks must be
created, before. See also chapter 12.4 "Parameter blocks".
Choose "test plan" in the main menu.
Create new test plans or edit existing test plans by insert "Input/Output"
parameter blocks. See also chapter 10.5.
The device is providing the definite "Input/Output" parameter blocks in
addition to the HV/IS ..... -parameter block to insert in the test plan.
Insert "Input/Output" blocks in the test plan-sequence, on the desired
position.
Save the value by using the "Save" Button.
Fig. 12.22: Insert Parameter set
Full-electronic G1-1 HV DC-Tester
Summary of Contents for G1-1
Page 38: ...38 4 OPERATING MODES 4 2 2 Normal mode input step Full electronic G1 1 HV DC Tester...
Page 39: ...39 4 OPERATING MODES 4 2 3 Normal mode output step Full electronic G1 1 HV DC Tester...
Page 40: ...40 4 OPERATING MODES 4 2 4 Normal mode time step Full electronic G1 1 HV DC Tester...
Page 133: ...Expires 04 19 2016...
