119
12. INPUT/OUTPUT TEST STEPS
12.6.2.3
Set Digital Output
Press the green "Run" - button, for start the set action.
Whether a digital output is set or not, is defined
in the parameter set.
Note:
In the example illustration the
expanded digital/analog interface
Option G1-1 E07 (chapter 12.3) is integrated in the tester. The additional
digital
interface
Option G1-1 E06 is not integrated. Therefore, the state
of the inputs 1 - 6 is "x".
In this case, the tester reports "Error: digital inputs" - forecasting: 1 signal
at input 1, specified "0" in the parameter block.
The tester is waiting for user input.
12.6.2.4
Set Analog Output
Press the green "Run" - button, for start the set action.
Whether a analog output is set or not, is defined
in the parameter set.
See also chapter 10.5.2 "auto testing".
State Digital Outputs
Values Analog Outputs
State Digital Outputs
Values Analog Outputs
Fig. 12.29: Set digital output
Fig. 12.30: Set analog output
Full-electronic G1-1 HV DC-Tester
Summary of Contents for G1-1
Page 38: ...38 4 OPERATING MODES 4 2 2 Normal mode input step Full electronic G1 1 HV DC Tester...
Page 39: ...39 4 OPERATING MODES 4 2 3 Normal mode output step Full electronic G1 1 HV DC Tester...
Page 40: ...40 4 OPERATING MODES 4 2 4 Normal mode time step Full electronic G1 1 HV DC Tester...
Page 133: ...Expires 04 19 2016...
