ELABO G1-1, Operating Instructions Manual

Page: 8 / 135

8
1. INTRODUCTION
Full-electronic G1-1 HV DC-Tester
No. Equipment Function
F1 Fuse drawer Adapter for mains fuse
S1/H1 Toggle switch/pilot lamp Mains switch with indicator lamp
S2/H2 Illuminated button Reset (red) Switching OFF test voltage / Reset
S3/H3 Illuminated button Set (green)
Ready for testing
Starting test run (only at display devices)
H4 TouchDisplay Operating of the tester
X1
Cold appliance mounting jack with
fuse adapter 10 A
Main cable connection / mains fuse (fine wire fuse
T 3.15 A - 5 x 20 mm)
X2 HV-jack Connection high voltage + / ~ (high potential)
X3 HV-jack Connection high voltage - / ~ (low potential)
X4 HV-jack Feed back of high voltage ( + / ~) for X2 (Option)
X5 HV-jack Feed back of high voltage ( - / ~) for X3 (Option)
X6 Socket (Warning Lamps) Connection warning lamps
X7 Socket (D-SUB 25pole) female DA-interface - digital Inputs/Outputs, Safety circuit
X8 Socket (D-SUB 37pole) male
DA-interface - additional digital/analog inputs/out-
puts (options)
X9 RJ45 (DSUB, USB) - socket
Ethernet bus interface (RS232, USB - option)
for automatic control of the tester (and firmware
update of touch display module)
X9a Socket (D-SUB 9pole)
RS-232 - Service-interface (firmware update control
module)
X11 HV-jack Connection high voltage - parallel to X2
X12 HV-jack Connection high voltage - parallel to X3