EDNord QMS 4060, Manual

Page: 83 / 340

Replacing the Pick
Rollers
2-59 Consumables
4 Locate the two retaining springs providing tension to the
lower roller assembly. Note how the springs are attached to
the roller shaft.
5 Remove the white plastic clip at the back side of the lower
roller shaft.
6 Grasp the lower roller assembly and slide it toward the front.
7 Set the lower roller assembly aside.
Removing LCIF Upper Roller Assembly
1 From the paper side of the LCIF, locate the upper roller
assembly.
2 On the printer side of the LCIF locate the two thumbscrews
and remove them while holding the upper roller assembly
up.
3 Note the top of the assembly. Grasp the upper roller assem-
bly and carefully pull it out and set it aside.
Installing the New LCIF Upper Roller Assembly
1 Hold the replacement upper roller assembly the same way as
you removed the old one.
2 Insert the new assembly shaft into the plastic cap and posi-
tion the assembly over the screw holes.
3 While holding the assembly with one hand, attach the two
thumbscrews. You may have to adjust the upper roller
assembly left or right so the screws can engage the holes.
4 Tighten the thumbscrews finger tight.
Installing the New LCIF Lower Roller Assembly
1 Grasp the new lower roller assembly and insert the shaft into
the holding tabs the same way you removed the old assem-
bly.
2 Slide it in and back into the other tab.
EDNord - Istedgade 37A - 9000 Aalborg - telefon 96333500