EDNord QMS 4060, Manual

Page: 130 / 340

Tray Chaining
QMS 4060 Print System Operation 5-4
Duplex Printing Tips
n
Select paper with high opacity for duplex printing. Opacity refers
to how effectively paper blocks out what is written on the opposite
side of the page. Paper with high opacity has low transparency. If
paper has low opacity (high transparency), then the printed data
from one side of the page will show through to the other side. For
best results, print a small quantity to make sure the opacity is
acceptable.
n
For duplex printing on pre-printed letterheads, place the sheet
face-down with the bottom of the page inserted first. In the duplex
mode, the printer prints side two first, then side one.
Tray Chaining
The QMS 4060 Print System comes standard with three 500-sheet
internal trays (also known as input bins) for a total paper capacity of
approximately 1500 sheets before a reload is necessary. You may
choose to have the printer automatically draw from another tray when
the current tray empties. Here are four ways to chain trays:
n
Your application may include a specific procedure for using a
multi-tray printer. Check your documentation.
n
The QMS Level 2 Windows printer driver allows you to select
alternate trays for chaining.
n
On a network, use CrownAdmin via a remote console to select
the paper trays and/or the paper source.
n
Configure the printer through its control panel. The following sec-
tion has more information.
EDNord - Istedgade 37A - 9000 Aalborg - telefon 96333500