EDNord QMS 4060, Manual

Page: 144 / 340

Starting a
Remote
Console
Session
QMS 4060 Print System Operation 6-4
» Note: If you are unsure about whether your cable is a modem-
based cable, then try to connect a null modem adapter to your
cable to test the local console port.
2 Connect the other end of the cable to the terminal.
3 Set up your terminal to operate at 9600 baud, no parity, 8
data bits, and 1 stop bit.
4 Turn on the terminal.
5 Turn on the printer.
You should see status messages as the printer begins its normal
initialization.
Starting a Remote Console
Session
Depending on your system and your network interface, you have one
of three ways to start a remote console session.
n
If you have a CrownNet interface card, see the appropriate chap-
ter of the
QMS CrownNet Interface System Administrator’s Man-
ual , which is included with your CrownNet shipment.
n
If you are not using CrownNet and are in a UNIX environment,
use the Telnet protocol described in this manual.
» Note: Whether you use a VMS host or a TCP/IP host with Telnet
commands, remote console works the same once you are in the
session.
Starting a Telnet Session
With No Password Set
» Note: Passwords can be set or changed only through the printer’s
control panel.
EDNord - Istedgade 37A - 9000 Aalborg - telefon 96333500