EDNord QMS 4060, Manual

Page: 131 / 340

Tray Chaining
5-5 Advanced Printing Features
Using the Configuration Menu
An option in the Operator Control menu allows you to “chain” input-
bins (trays) so that when the first inputbin empties, the printer will
automatically draw paper from another inputbin with either the same
or any size and type of paper (dependent on the choice selected).
Menu Operator Control/Chain Inputbins
Choices On—Switch to the next inputbin with the same size
and type of paper when the default inputbin is
empty.
» Note: Make sure the three trays use the same
size paper.
Off—Don’t switch inputbins; use only the default
inputbin.
On Any—Switch to the next inputbin with similar size
of paper when the default inputbin is empty.
Default On
Notes Use the Operator Control/Inputbin menu to set the
default inputbin. Make sure that the three inputbins
use the same size paper.
When chaining “on any” and duplexing, the printer will
chain to a similar size paper (for example, letter to A4)
but not to the large paper sizes—11"x17" and A3.
This is because these large sizes are fed through the
printer in a different printing order than the smaller
sizes. The custom tray chaining on any for large
format paper will not occur unless there is another
custom tray with the same paper size or a standard
tray with A3 or 11"x17" paper.
When these restrictions occur on chaining on any, the
printer will prompt you to add the default paper size to
any tray.
EDNord - Istedgade 37A - 9000 Aalborg - telefon 96333500