EDNord QMS 4060, Manual

Page: 147 / 340

Starting a
Remote
Console
Session
6-7 Local and Remote Console
2 The system is busy.
If a positive acknowledgment to a request for opening a remote
console session is not received by the daughterboard within a
given time limit (which depends on the daughterboard and com-
munication protocol being used), the daughterboard cancels the
request. This may occur when the system is very busy.
Try again when the system is not busy.
Starting a DECnet Session
To use remote console on a DECnet setup, do the following:
1 Have your system administrator install the QMS PS Execu-
tive for VMS on your system.
2 Use the VMS utilities to connect to the printer.
With your system running, go to the VMS prompt. Then, type the
following:
RUN SYS$SYSTEM:QMS$PSEXEC
↵
The first screen in PS Executive prompts you for the nodename of
the printer.
$RUN SYS$SYSTEM:PSEXEC
What is the QMS printer nodename->
3 Enter the nodename for the printer whose settings you want
to view.
This name was assigned to the printer by the system administra-
tor during client software installation. If you do not know the node-
name, ask your administrator or use the method appropriate to
your environment.
n
In a Phase IV environment, type
$ MC NCP SHOW KNOWN NODES
↵
This command lists your accessible nodes.
EDNord - Istedgade 37A - 9000 Aalborg - telefon 96333500