EDM Solution 862, Installation Manual

Page: 85 / 262

System Functions 85
Setting STAY Mode 2 Zones
This function allows the installer to select which zones are to be automatically isolated when
the system is armed in STAY Mode 2.
Every time the system is armed in STAY Mode 2, the zones selected using this function will be
automatically isolated.
To arm the system in STAY Mode 2, hold down the
0
button until two beeps are heard.
Refer to Hold Down Functions on page 107 or Arming The System In STAY Mode 2 on page
57 for more information.
How To Set STAY Mode 2 Zones
1. Enter your followed by
4
and the button.
Three beeps will be heard and the
STAY
indicator will begin to flash.
2. * Enter the that you wish to automatically isolate followed by the
button. The corresponding ZONE indicator will begin to flash to display that you have
selected the zone to be automatically isolated every time you arm the system in STAY
Mode 2.
If more than one zone is required to be automatically isolated in STAY Mode 2, repeat
step 2 until all zones required have been selected.
3. Press the button to exit this function.
Two beeps will be heard and the system will return to the disarmed state. The zones
that were selected to be automatically isolated in STAY Mode 2 along with the
STAY
indicator will extinguish.
+
4
+
+ + +
4
* As each zone has been selected to be isolated, the cor
If a mistake has been made, press the zone number that was
responding ZONE indicator will
begin to flash.
incorrectly entered followed by the button. This zone is now no longer
programmed to be isolated and the ZONE indicator will extinguish.
Example
If you wish to select zones 2, 5 and 6 to be automatically isolated when arming in STAY Mode
2, follow the sequence below.
1234
+
4
+
+
2
+ +
5
+ +
6
+ +
Electronics Design and Manufacturing Pty Limited ISSUE130