EDM Solution 862, Installation Manual

Page: 151 / 262

User Codes 151
User Codes
LOCATION 185 - 264
The purpose of user codes is to arm and disarm the system as well as perform other specific
functions as described in Master Code Functions on page 89.
User codes (1–8) can be any length between one to four digits long. Each user code may have
a different priority level multiple user codes may have the same priority level. The priority
level controls the behaviour of the code, allowing it to arm only, arm and disarm or be a Master
Code holder etc. The priority level of each user code is programmed in the last location of
each user code and can only be changed by the installer. A Master Code holder does not have
the ability to change priority levels.
15 15 15 15 0
User Code Priority
There are a total of 16 user codes available that can be changed or deleted at any time by a
Master Code holder, however, user codes 9 – 16 can only be remote radio user codes. Refer to
Remote Radio Transmitter Operations on page 68 for more information. Multiple Master
Codes can be programmed. Refer to Master Code Functions on page 89 for more information
on adding, deleting or changing user codes.
The priority level for each user code can only be programmed or altered by the installer.
User Code 16 will report when any of the following methods for arming and disarming are
used.
1. Arm and disarm via remote radio control equipment connected to the optional Radio
Key/Keyswitch Interface (CC813).
2. Arm and disarm the system via Alarm Link Software (CC816).
3. Arm the system remotely over the telephone.
4. Single button arming in AWAY Mode, STAY Mode 1 or STAY Mode 2.
5. Single button disarming from STAY Mode 1 or STAY Mode 2.
6. Automatic arming in AWAY Mode or STAY Mode 1.
7. Automatic disarming from AWAY Mode or STAY Mode 1 or STAY Mode 2
Electronics Design and Manufacturing Pty Limited ISSUE130